Hi! After a long hiatus I have decided to revamp the blog and start posting again. So...enjoy!I present to you a super comfortable and simple diy summer dress. And it only takes two yards of fabric! This dress was made with a polyester print fabric (which was so not fun to work with, but it's pretty, so I'm good with that) and one invisible zipper inserted in the side of the garment. I used a 22" one, but ended up trimming quite a bit off of it. I finished the hem with lace hem tape which makes the boring task of hemming kind of fun and gives it a bit more weight, important for such a lightweight fabric. Also, I used a 1/2" seam allowance.
The dress consists of 4 pattern pieces: the bodice (with two neckline variations), the skirt panel, the waistband and the straps.
The bodice pattern piece looks more confusing than it really is. Just use common sense. Cut a bodice piece of each neckline (on the fold) out of your outer and lining fabrics. You should have four bodice pieces. Then cut a long skinny piece for the straps. I made mine about 2" wide x 30" long.
Then cut your two skirt panels and 2 waistband pieces.
The Bodice:
To start, sew together the outer bodice pieces on the right side. Sew the lining pieces together on the left side. Do the same on the opposite side, only stitch about 3" down (to leave room for the zipper). Then, with right sides together, sew down the long side of the strap piece. Pull the end through to turn the strap right-side-out. I use one of these.With outer and lining fabric right sides together, sew the arm holes and neckline, leaving the strap section open. Try on the bodice and figure out how long you want your straps to be (+1" for seam allowance). Cut two straps out of the long tube you made. Iron them flat. With bodice pieces still right sides together, thread the straps through the strap openings, being careful not the twist them. Pin and stitch in place, meeting the seams you made on either side for the arm hole and neckline. Turn bodice right side out.
Stitch two lines of gathering stitches around the bottom of the bodice, keeping the edges even. Gather the bottom so that it matches your waistband length.